To begin with, we shall start off with a basic grass patch asset. When we declare a grass asset to be a patch, we are actually referring to it as being a collection of randomly rotated planes of various sizes that are all baked into a single *.cgf file. The idea behind this setup is to have a single CGF file to cover a wide area (approximately 8m), hence to fill an area with grass you need less vegetation asset instances to completely cover the area.

For more information about using the Vegetation Editor in CRYENGINE, please go HERE.

Pic 1: Example of 3 grass patch models, a dense, medium and light variation.

Pic 2: Example using the grass patches to fill an area with vegetation.

Helpful Information

Keep the following things in mind while working on your asset:

Limitations of Grass Patches

Cannot Handle Big Changes in Terrain Angles

Grass patches are good for most use cases, although there are few instances where this is not the case. Since a patch covers a large portion of space (recommended to be approximately 8 meters), it is still considered as a flat plane. Hence, when you encounter variation in the terrain (different heights) some variation can be dealt with, however when extreme angles are encountered then it will adjust itself to be aligned perpendicular to the terrain. Since the patch is large, this can cause over flow into empty spaces.

In the example below (Pic 3: Grass patch limitation), the grass is shown growing at an extreme angle (an unrealistic condition) which demonstrates the limitation of the grass patch. In this case, use the Merged Mesh Grass due to its smaller footprint.

Pic 3: Grass patch limitation.

Doesn't Support Merged Mesh (MM) Technology

Due to the nature of Merged Mesh (MM) technology (which requires a very simple geometry setup of just 4 to 8 polys), when a geometry layout which consist of multiple mesh planes aligned at random angles, it becomes too complex to take advantage of this technology. 


The following topics below explains the pipeline depending on the DCC tool you use, followed by the final CRYENGINE setup.